MN-4-2-1-1-001 - Receiving solicited MPA
Host
|
R CN0
| |
-----+-------+--------+---------------- LinkZ
|
R2 NUTY
| |
-----+-------+-----------------+------- LinkY
|
R1 NUTX
| |
-----+-------+-----------------+------- LinkX
|
HA0 Node0 NUT0
| | |
----------------------+---------------+---------+------- Link0
| Link0 |
3ffe:501:ffff:100::/64 |
home link |
| LinkX |
3ffe:501:ffff:102::/64 |
|
| LinkY |
3ffe:501:ffff:103::/64 |
|
| LinkZ |
3ffe:501:ffff:104::/64 |
|
| HA0(Link0) |
3ffe:501:ffff:100:200:ff:fe00:a0a0 |
|
| Node0(Link0) |
3ffe:501:ffff:100:200:ff:fe00:a3a3 |
|
| R1(LinkX) |
3ffe:501:ffff:102:200:ff:fe00:a4a4 |
|
| R2(LinkY) |
3ffe:501:ffff:103:200:ff:fe00:a6a6 |
|
| CN0(LinkZ) |
3ffe:501:ffff:104:200:ff:fe00:a8a8 |
|
1. Selection Option
- none
2. Position of Mobile Node
- none
HA0 NUT0 R1 R2 CN0
| | | | |
| ----> | | | | 1.Router Advertisement
| | | | |
| NUTX | | |
| | | | |
| | <---- | | | 2.Router Advertisement
| | | | |
| <---- | | | | 3.Neighbor Solicitations
| | | | | 4.(no reply:3 seconds)
| | | | |
| <---- | | | | 5.Binding Update
| ----> | | | | 6.Binding Acknowledgement
| | | | |
| ----> | | | | 7.Mobile Prefix Advertisement
| <---- | | | | 8.Mobile Prefix Solicitetion
| ----> | | | | 9.Mobile Prefix Advertisement
| | | | | 10.(wait) (*1)
| | | | |
1. Send Router Advertisement. (HA0 -> HA0_allnode_multi)
2. Send Router Advertisement. (R1 -> R1_allnode_multi)
3. Receive Neighbor Solicitations. (NUT0 -> HA0)
4. (no reply)
# Wait during a maximum of 3 seconds(RFC2461).
5. Receive Binding Update. (NUTX -> HA0)
6. Send Binding Acknowledgement. (HA0 -> NUTX)
7. Send unsolicited Mobile Prefix Advertisement. (HA0 -> NUTX)
# The Identifier field is set to the random value.
8. Receive Mobile Prefix Solicitation. (NUTX -> HA0)
9. Send Mobile Prefix Advertisement. (HA0 -> NUTX)
# The Source Address is set to HA address.
# The Destination Address matches Source Address
# in the Mobile Prefix Solicitation[8].
# The type2 routing header is included.
# The Identifier field matches the Identifier field
# in the Mobile Prefix Solicitation[8].
# The Prefix Information option is included, and,
# - The Router Address(R) flag is set to ON.
# - The Valid Lifetime is not changed.
# - The Preferred Lifetime is not changed.
10. (wait)
# Wait during enough retransmission timer.
Packet Format is:
9.Mobile Prefix Advertisement
(*1) PASS: HA0 does not receive the retransmitting of Mobile Prefix
Solicitation message.
(draft-ietf-mobileip-ipv6-24.txt)
11.4.3 Receiving Mobile Prefix Advertisements
(snip)
When a mobile node receives a Mobile Prefix Advertisement, it MUST
validate it according to the following test:
o The Source Address of the IP packet carrying the Mobile Prefix
Advertisement is the same as the home agent address to which the
mobile node last sent an accepted home registration Binding Update
to register its primary care-of address. Otherwise, if no such
registrations have been made, it SHOULD be the mobile node's
stored home agent address, if one exists. Otherwise, if the
mobile node has not yet discovered its home agent's address, it
MUST NOT accept Mobile Prefix Advertisements.
o The packet MUST have a type 2 routing header and SHOULD be
protected by an IPsec header as described in Section 5.4 and
Section 6.8.
o If the ICMP Identifier value matches the ICMP Identifier value of
the most recently sent Mobile Prefix Solicitation and no other
advertisement has yet been received for this value, then the
advertisement is considered to be solicited and will be processed
further.
Otherwise, the advertisement is unsolicited, and MUST be silently
discarded. In this case the mobile node SHOULD send a Mobile
Prefix Solicitation.
Any received Mobile Prefix Advertisement not meeting these tests MUST
be silently discarded.
6.8 ICMP Mobile Prefix Advertisement Message Format
(snip)
Source Address
The home agent's address as the mobile node would expect to see it
(i.e., same network prefix).
Destination Address
If this message is a response to a Mobile Prefix Solicitation,
this field contains the Source Address field from that packet.
For unsolicited messages, the mobile node's care-of address SHOULD
be used. Note that unsolicited messages can only be sent if the
mobile node is currently registered with the home agent.
Routing header:
A type 2 routing header MUST be included.
(snip)
Identifier
An identifier to aid in matching this Mobile Prefix Advertisement
to a previous Mobile Prefix Solicitation.
(snip)
Reserved
This field is unused. It MUST be initialized to zero by the
sender and MUST be ignored by the receiver.
(snip)
Prefix Information
Each message contains one or more Prefix Information options.
Each option carries the prefix(es) that the mobile node should use
to configure its home address(es). Section 10.6 describes which
prefixes should be advertised to the mobile node.